skip to Main Content

The stationary machine КШ003 is designed for seam resistance welding of different products with cross composite weld, including flange welding of gasoline tanks (inclination of the rollers 600) , as well as for welding on of the heads and shells of low-carbon and stainless steel with galvanic coating and without coating.

The machine is made with a roller drive for each roller and inclined wheel electrodes. The machine is equipped with a welding process control system built on a programmable controller, which provides automatic stabilization of the set parameters with indication of the actual values​​.
Controller type SERRATRON 1А or SERRATRON 1В (Spain).

Parameter name Rate
Rated mains voltage at frequency 50 Hz, V380
Maximum short circuit power, kVA280
Power at DC=50%, kVA270
Rated continuous secondary current, kA22
Maximum secondary current, kA32
Maximum compressive force, daN1350
Rated stick-out, mm300
Linear speed of electrodes, m/min0,4 - 6,0
Range of thicknesses to be welded, mm:
- low-carbon steel от 0,5+0,5 до 3,0+3,0
- stainless steelот 0,3+0,3 до 2,5+2,5
Linear speed of rollers, m/min0,4 - 4,7
Maximum Electrode spacing, mm:128
Weight, kg1600
Overall dimensions, mm1740х795х2060
Regulator type (by order )Serratron 1A
Serratron 1B

Advantages:

• Rigid housing eliminating all possible deformations during welding;
• The original design of connection of the welding rollers to the electrode shaft, which ensures alignment of the welding roller planes with each other;
• Availability of two ranges of welding forces depending on the products to be welded:
a) range of small forces;
b) range of great forces;
• Availability of a foot-operated button having a flexible coupling with the machine, which allows installing it in a place convenient for work
• Pneumatic compression drive;
• Availability of a pneumatic device that provides power with the cleaned compressed air and control of the pneumatic drive operation;
• Smooth pressure adjustment in the working chambers of the pneumatic drive;
• Smooth adjustment of the working travel of the electrode when welding products with projections, walls and other complex configuration elements of the welded products;
• Availability of water cooling of electrodes, elements of current contact jaws, electrode shaft and welding transformer;
• Smooth operation of the pneumatic drive;
• Separate adjustment of air pressure supplied to the middle and lower chambers of the cylinder;
• Rapid build-up of the increased effort of the pneumatic drive;
• Availability of a pressure relay, which ensures switching off of the welding current when the required pressure of the cooling liquid is decreased;
• The angle of inclination of the wheel electrodes allows welding in hard-to-reach places;
• Adjustment of the lower electrode in height to compensate its wear;
• Availability of roller drive;
• SERRATRON 1А welding controller supports 16 different modes of welding modes, the parameters of the welding modes are set via the portable programmer for storage in the controller’s memory;
• SERRATRON 1В welding controller supports 256 different modes of resistance welding, the parameters of the welding modes are set via the operator panel for storage in the controller’s memory;
• SERRATRON 1А, SERRATRON 1В welding controllers have a current feedback;
• Automatic stabilization of the set parameters with indication of actual values;
• Possibility of current modulation in the welding pulse.

×Close search
Search